Total Knee Joint Prostheses Wear Tester

Standard 

• ISO 14243-1:2014: Specifies wear testing parameters for total knee prostheses, including axial loading, flexion/extension kinematics, and environmental conditions.
• ISO 14243-3:2014: Defines protocols for simulating physiological loading, displacement, and rotation during knee joint wear testing.
• ASTM F3297-18: Additional compliance for advanced testing scenarios including high-flexion and pivot-shift motions.

Product Advantages

1. Hexapod Motion Control: 6-DOF kinematic simulation replicates natural knee motion (flexion/extension ±120°, AP displacement ±15 mm, tibial rotation ±20°).
2. Dynamic Load Management: Dual-axis load control (axial 0–3,000 N, shear 0–500 N) with 0.1% force accuracy.
3. Biorelevant Environment: Temperature-controlled (37±1°C) lubrication bath with 20±2 g/L protein concentration.
4. Extended Durability: Capable of 10+ million cycle testing with <0.3% drift in calibration.
5. Automated Compliance: Pre-programmed ISO/ASTM test protocols with real-time data validation.
6. Modular Design: Four-station configuration allows parallel testing of multiple specimens.

Product Features

• Electrohydraulic Actuation: Six independent servo-hydraulic actuators for precise motion control.
• 6-Axis Force/Torque Sensors: Measure axial forces, shear forces, and torsional moments simultaneously.
• Temperature-Controlled Bath: Recirculating lubrication system with protein skimmer and pH monitoring.
• High-Resolution Imaging: Optional integration with micro-CT systems for in-situ wear analysis.
• AI-Powered Analytics: Machine learning algorithms predict wear rates from initial test cycles.
• Safety System: Emergency stop, over-pressure relief, and laser-based specimen breakage detection.

技術パラメータ

Accessories

1. Knee Simulator Fixture Kit:
   • Self-centering femoral/tibial component adapters (28–40 mm)
   • Patella-femoral contact jigs (30°–60° Q-angle adjustability)
2. Biorelevant Bath System:
   • 10L capacity with recirculation pump and protein skimmer
   • 316L stainless steel construction with HEPA filtration
3. WearMaster Pro Software:
   • Automated wear rate calculation (mass loss/volume displacement)
   • 21 CFR Part 11-compliant audit trail with blockchain timestamping
   • Remote monitoring via iOS/Android app
4. Operator Kit:
   • Calibrated torque wrench set (1–50 Nm)
   • Specimen alignment gauges (ISO 14243-1 compliant)
5. Calibration Bundle:
   • NIST-traceable force calibration weights
   • Angular encoder verification tool
6. Safety Kit:
   • Laser safety curtains
   • Acoustic enclosure with 30 dB noise reduction